New methods of installing RV cover save your time. Thick, triple layer polypropylene top fabric keeps out rain and snow yet vents inside water vapor out. Resistant, single layer polypropylene fabric sides. Protecting your investment from Harsh UV ray and keep interior cool. It's not easy to fade and protect your RV looks new.Size: 238"Lx 108"Wx 106H. There are 2 pockets on each side panel top near the end of the cover. Need 2 person point the steel poles into each pocket and lift it up at the same time. Spread the entire cover on clean ground, find out the front panel or back panel first. Unzip the zippers of BACK panel of RV cover, roll up BACK panel completely and secure it on top panel with sew-in velcro tapes. 2 person point the steel poles into each pocket and lift it up at the same time. Tip: the poles should be hard and straight enough, 2 meters in length at least. Both of operators stand by the end of RV, raise the cover up over the roof of RV, pull the cover carefully from the end to the front of RV until the cover is on the correct position. Tip: If you feel hard to moving forward, check if the cover is stuck by any corners or sharp edges of RV roof. If it was stuck, operators can move to pockets on the middle of cover, and pull again. Release the front panel from velcro, zip all zippers, put all buckles & straps on, and done. How to select the Right Size Cover. Please measure your RV to ensure a proper fitting size. Overall length includes bumper , but not hitch. Pls add 1 foot to total length if you have a roof mounted AC unit. Measurement included spare tire if mounted to the back of your camper. The item "New Easy Setup Truck Camper Cover Fits RV 10'-12' with Assist Poles" is in sale since Sunday, September 4, 2016.
This item is in the category "eBay Motors\Parts & Accessories\RV, Trailer & Camper Parts\Exterior". The seller is "leaderaccessories" and is located in Beloit, Wisconsin.
This item can be shipped to United States.